Car rear suspension Ford Scorpio 1
Rear suspension specifications
The rear suspension is independent, on three-arm oblique levers, pivotally connected to the rear axle beam, coil springs and double-acting telescopic shock absorbers...
The rear suspension is independent, on three-arm oblique levers, pivotally connected to the rear axle beam, coil springs and double-acting telescopic shock absorbers...
Description of the rear suspension design
Rear suspension Rear suspension parts 1 – metal-rubber bushing of the lever, 2 – semi-trailing arm, 3 – rear support, 4 – rubber stop, 5 – upper spring cup, 6 –...
Rear suspension Rear suspension parts 1 – metal-rubber bushing of the lever, 2 – semi-trailing arm, 3 – rear support, 4 – rubber stop, 5 – upper spring cup, 6 –...
Replacing the rear shock absorber
1. Remove the trunk trim piece and the trunk bottom covering. 2. Raise the rear of the vehicle. 3. Using a suitable lift, support the lever through a wooden block. 4. On...
1. Remove the trunk trim piece and the trunk bottom covering. 2. Raise the rear of the vehicle. 3. Using a suitable lift, support the lever through a wooden block. 4. On...
Replacing the suspension spring
Removal 1. Remove the rear wheel cover and loosen the wheel nuts. 2. Raise and secure the rear of the vehicle and remove the corresponding rear wheel. 3. Unscrew the six...
Removal 1. Remove the rear wheel cover and loosen the wheel nuts. 2. Raise and secure the rear of the vehicle and remove the corresponding rear wheel. 3. Unscrew the six...
Removal and installation the suspension arm
1. Remove the rear wheel cover and loosen the wheel nuts. 2. Raise and secure the rear of the vehicle and remove the corresponding rear wheel. 3. Remove the rear muffler...
1. Remove the rear wheel cover and loosen the wheel nuts. 2. Raise and secure the rear of the vehicle and remove the corresponding rear wheel. 3. Remove the rear muffler...
Replacing the metal-rubber bushing of the rear axle beam
1. Raise and secure the rear of the vehicle. 2. Unscrew the bolts (1) securing to the body and the fasteners (2) of the metal plate of the metal-rubber bushing of the...
1. Raise and secure the rear of the vehicle. 2. Unscrew the bolts (1) securing to the body and the fasteners (2) of the metal plate of the metal-rubber bushing of the...
Removal and installation the stabilizer
1. Raise and secure the rear of the vehicle. 2. Disconnect the stabilizer (indicated by the arrow) from the struts. 3. Unscrew the bolts (indicated by the arrow)...
1. Raise and secure the rear of the vehicle. 2. Disconnect the stabilizer (indicated by the arrow) from the struts. 3. Unscrew the bolts (indicated by the arrow)...
Replacing wheel hub bearings
Rear hub 1 – outer seal ring, 2 – outer bearing, 3 – bearing housing, 4 – inner bearing, 5 – inner seal ring 1. Remove the rear wheel cover and loosen the wheel nuts. 2....
Rear hub 1 – outer seal ring, 2 – outer bearing, 3 – bearing housing, 4 – inner bearing, 5 – inner seal ring 1. Remove the rear wheel cover and loosen the wheel nuts. 2....
Ground clearance adjustment system
Elements of the ride height adjustment system 1 – compressor, 2 – moisture separator, 3 – connector, 4 – electromagnetic pressure relief valve, 5 – height sensor, 6 –...
Elements of the ride height adjustment system 1 – compressor, 2 – moisture separator, 3 – connector, 4 – electromagnetic pressure relief valve, 5 – height sensor, 6 –...
Removal and installation the compressor
1. Remove the ground wire from the battery. 2. Raise the front of the vehicle and secure it on stands. 3. Unscrew the four bolts securing the compressor cover and remove...
1. Remove the ground wire from the battery. 2. Raise the front of the vehicle and secure it on stands. 3. Unscrew the four bolts securing the compressor cover and remove...
Replacing the height sensor
1. Remove the ground wire from the battery. 2. Raise the rear of the vehicle and secure it on stands. 3. Remove the rocker arm joint and electrical connector from the...
1. Remove the ground wire from the battery. 2. Raise the rear of the vehicle and secure it on stands. 3. Remove the rocker arm joint and electrical connector from the...
This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Fusion
Scorpio 1
Scorpio 2
Sierra
- General information
- Vehicle device
- User manual
- Faults on the way
- Maintenance
- Tips for the car owner
- Power unit
- Engine repair
- Lubrication and cooling system
- Supply system
- Exhaust and vapor recovery
- Transmission
- Clutch
- Car gearbox
- Front wheel drives
- Chassis
- Front suspension
- Rear suspension
- Steering
- Brake system
- Wheels and tires
- Body
- Exterior
- Interior
- Doors, locks and windows
- Body сare
- Electrical equipment
- Equipment and devices
- Engine electrics
- Lighting and signaling
- Switches and sensors
- Electrical circuits
Scorpio 1
- General information
- User manual
- Maintenance
- Power unit
- Petrol engines OHC
- Petrol engines DOHC
- Petrol engines V6
- Ignition and control
- Diesel engines
- Cooling system
- Supply system
- Carburetors
- Fuel injection
- Transmission
- Clutch
- Manual gearbox «N»
- Manual gearbox «MT 75»
- Automatic gearbox «A4LD»
- Rear axle and drive shafts
- Chassis
- Steering
- Power steering
- Front suspension
- Rear suspension
- Brake system
- Body
- Exterior
- Interior
- Doors, locks and windows
- Heating and ventilation
- Electrical equipment
- Equipment and devices
- Power devices
- Electrical circuits
Scorpio 2
- General information
- Car care
- Maintenance
- Power unit
- Engine repair
- Lubrication system
- Cooling system
- Ignition system
- Supply system
- Carburetors
- Injection system (gasoline)
- Injection system (diesel)
- Exhaust system
- Transmission
- Clutch
- Car gearbox
- Chassis
- Front suspension
- Rear suspension
- Steering
- Brake system
- Wheels and tires
- Body
- Exterior
- Interior
- Doors, locks and windows
- Heating system
- Electrical equipment
- Equipment and devices
- Headlights and lighting
- Windshield wipers and washers
- Power devices
- Electrical circuits
Sierra
- General information
- User manual
- Maintenance
- Gasoline engines
- Engine repair
- Ignition system
- Fuel system
- Cooling and lubrication system
- Changes 1984-1986
- Changes 1987-1989
- Changes 1990-1993
- Diesel engines
- Engine repair
- Fuel system
- Cooling and lubrication system
- Changes 1988-1993
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Cardan and rear axle
- Chassis
- Steering
- Steering with power steering
- Front suspension
- Rear suspension
- Brake system
- Body and electrical
- Body elements and doors
- Electrical equipment
- Electrical circuits