Contents: Removal ↳ Installation ↳
Removal
1. Remove the rear wheel cover and loosen the wheel nuts.
2. Raise and secure the rear of the vehicle and remove the corresponding rear wheel.
3. Unscrew the six bolts securing the outer flange of the drive shaft.
4. Disconnect the anti-roll bar from the strut.
5. On vehicles with adjustable ride height, disconnect the line from the shock absorber.
6. Disconnect the brake pipes from the mounting brackets on the lever and the body.
7. When removing the left spring, unscrew the tee with the brake pipes from the body.
8. Place a jack under the suspension arm and raise the arm so that the entire load is on the suspension spring.
9. Unscrew the lower mount (indicated by the arrow) of the shock absorber.
10. Unscrew the bolts securing the rear axle beam to the body on the corresponding side after bending back the safety gasket and unscrewing the bolt securing the metal-rubber bushing, as well as the two bolts securing this bushing to the body.
11. Carefully lower the lever down.
12. Remove the suspension spring together with the rubber support cup.
Installation
To install the suspension spring, perform the steps in reverse order to the removal process.
The original can be found on the specified resource: FordBook.ru