Car engine cooling system Ford Scorpio 2

Coolant circulation
The cooling system mainly consists of a radiator, a coolant pump, a thermostat and a fan. The circulation of the coolant is regulated by a thermostat. When the engine is...

Coolant — Basic Information
The cooling system is filled at the factory with a coolant consisting of a mixture of water, FORD antifreeze and an anti-corrosion additive. This prevents the liquid...

Replacing the coolant
If the cooling system is filled with a mixture of water and antifreeze Super Plus 4 or FORD SUPER PLUS 2000, then there is no need to replace the coolant as part of...

Checking the cooling system for leaks
The cooling system leakage and the operation of the safety valve in the radiator cap can be checked with a special device for testing the system under pressure. Such a...

Removal and installation thermostat (OHC engine)
As the engine heats up, the thermostat opens the coolant circuit through the radiator. If the thermostat valve does not open due to a defect, the engine overheats. This...

Removal and installation the thermostat (DOHC engine)
Removal Drain the coolant into a clean container. Disconnect the combination plug connector of the thermal switch. Loosen the clamps and remove the upper coolant hose...

Removal and installation the thermostat (V6 engine)
Removal Drain the coolant into a clean container. Loosen the clamps and remove the lower coolant hose "B" and the heating system hose "A". Unscrew the 3 bolts securing...

Removal and installation the thermostat (diesel engine)
Removal Drain the coolant into a clean container. Unscrew the 3 bolts securing the "arrow" and remove the coolant outlet pipe together with the sealing ring and...

Checking the Thermostat
Slowly heat the thermostat in a bath of water. The thermostat should not touch the walls of the bath and should be completely immersed in water. Monitor the water...

Removal and installation the cooling system fan
ONS and V6 engines Removal Remove the upper fan guide shroud. Using a 32 mm or 36 mm bent wrench, loosen the fan mount to the coolant pump hub. Note: The fan mounting...

Removal and installation the coolant pump
The coolant pump cannot be repaired. If a malfunction occurs, the pump must be replaced. If the shaft seal is not tight, the coolant, especially when the engine is...

Removal and installation the radiator
Removal After a long mileage of the car, narrow channels in the radiator may become clogged with coolant sediment and salt deposits. As a result, the radiator...

Diagnostics of cooling system faults
Diagnostics of cooling system faults Malfunction: the coolant temperature is too high, the temperature gauge needle is in the red zone of the scale on the instrument...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Fusion
Scorpio 1
Scorpio 2
Sierra