Engine lubrication and cooling system Ford Fusion

Design features of the engine lubrication system
The lubrication system is combined: the most loaded parts are lubricated under pressure, and the rest are lubricated either by directed splashing or splashing of oil...

Removal and installation the oil pump
The oil pump is removed for repair when its supply decreases, causing a constant drop in oil pressure in the engine lubrication system, and also when oil leaks through...

Oil pump repair
You will need: a 6 mm Allen key, a T30 TORX key, a caliper, and a set of flat feeler gauges. 1. Remove the oil pump from the vehicle (see " Removal and installation the...

Features of the design of the engine cooling system
Fig. 5.12. Cooling system: 1 – expansion tank cap; 2 – heater supply hose; 3 – heater outlet hose; 4 – distributor housing; 5 – radiator supply hose; 6 – radiator; 7 –...

Removal and installation the electric fan of the radiator of the cooling system
You will need a 10mm socket head. 1. Disconnect the wire from the negative terminal of the battery. 2. Disconnect the wiring harness connector from the fan motor. 3....

Replacing the cooling system radiator
You will need a 10mm socket head. 1. Disconnect the wire from the negative terminal of the battery. 2. Drain the coolant (see " Replacing the coolant "). 3. Disconnect...

Removal and installation the water pump
Remove the pump for repair or replacement if it produces noise during operation that exceeds the normal level and coolant leaks. Disassembling the pump is quite...

Removal and installation the thermostat
The need to remove the thermostat may arise for its replacement if the engine temperature is unstable - overheating or insufficient heating. To check the thermostat on a...

Removal and installation the expansion tank
You will need a 10mm socket head. 1. Drain the cooling system (see " Replacing the coolant "). 2. Unscrew the expansion tank mounting bolt… 3. ...pry up the retainer...