Car gearbox Ford Fusion

Gearbox design features
Ford Fusion cars are equipped with a Durashift five-speed manual transmission as standard. Upon request, cars with a 1.4-liter gasoline engine can be equipped with an...

Gearbox oil change
The design of the gearbox does not provide for oil replacement during the entire service life of the vehicle. However, the need to change the oil may arise, for example,...

Replacing gearbox seals
You will need: a flat-blade screwdriver, a hammer, and a mandrel. 1. To replace the axle shaft seal, drain the oil from the gearbox (see " Gearbox oil change "). 2....

Removal and installation the gearbox
The main faults that require removing the manual transmission from the vehicle to fix are the following: increased (compared to usual) noise; difficult gear shifting;...

Replacing gearbox control cables
You will need a 10 mm wrench. 1. Remove the gearbox control lever linkage (see " Removal and installation the gearbox control lever linkage "). 2. Remove the engine...

Removal and installation the gearbox control lever linkage
You will need: a flat-blade screwdriver, a 10 mm socket wrench, and a hammer. 1. Remove the floor tunnel lining (see " Removal and installation the floor tunnel lining...

Adjusting the gearbox control drive
The gearbox control drive consists of two cables: gear selection and gear shifting, but only the gear selection cable is adjustable. You will need: a metal rod with a...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Fusion
Scorpio 1
Scorpio 2
Sierra