Manual gearbox type «N» Ford Scorpio 1

Technical characteristics of the mechanical gearbox type «N»
The gearbox has three shafts, a classic design, four synchronized forward gears and an unsynchronized reverse gear. The drive shaft pinion and the driven shaft pinions...

Description of the design of the mechanical transmission type «N»
Five-speed manual transmission type N Housing of a mechanical five-speed gearbox 1 – front part of the crankcase; 2 – middle part of the crankcase; 3 – rear part of the...

Removal and installation the gearbox
Removal 1. Place the vehicle over the inspection channel or lift it on a lift. 2. Disconnect the ground cable from the battery. 3. On V6 models, remove the shielded...

Gearbox gears and shafts — design description
Gears and shafts of the gearbox 1 - retaining ring, 2 - retaining ring, 3 - ball bearing, 4 - primary shaft, 5 - radial roller bearing with needle rollers and two rings,...

Disassembling a manual gearbox
1. Clean the gearbox surface with kerosene and wipe it dry. 2. Remove the clutch release bearing together with the lever. 3. Unscrew and remove the reversing light...

Assembly of a manual gearbox
Before assembly, wash and check the condition of bearings, synchronizers and gears. The gearbox assembly is performed in the reverse order of its disassembly. During...

Gear shift mechanism — design description
Gear shift mechanism of a five-speed gearbox 1 – control shaft, 2 – selector, 3 – spring lock ring, 4 – 3rd–4th gear forks, 5 – 1st–2nd gear forks, 6 – 5th gear forks, 7...

Disassembling the secondary shaft of the gearbox
Disassembling the secondary shaft 1 – sealing ring, 2 – 1st gear pinion, 3 – 1st gear synchronizer ring, 4 – 1st–2nd gear synchronizer 1. Remove the retaining ring and...

Assembly of the secondary shaft of the gearbox
Installing the speedometer drive gear Size A = 123.5±0.5 mm. 1. Before assembly, lubricate the surfaces of interacting parts with gearbox oil. 2. Install the secondary...

Disassembly and assembly of the intermediate shaft gear block
Disassembling the intermediate shaft gear block is not particularly difficult. Care should be taken not to lose the bearing needles and the spacers (front and rear) of...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Fusion
Scorpio 1
Scorpio 2
Sierra