Exterior (external body elements) Ford Scorpio 1

Car body wash and care
Car body wash In most populated areas, it is prohibited to wash a car in open areas, except for specially designed places where dirty water is drained. If possible, wash...

Removal and installation the hood
1. Open the hood. 2. Use paint to mark the position of the hood hinges relative to the hood. 3. Unscrew the bolts (indicated by arrows) securing the hood hinge. 4....

Removal and installation the hood cable
If the cable breaks, the hood lock can be opened from under the car using a long screwdriver. 1. For better access, the front of the vehicle must be raised. 2. Unscrew 2...

Removal and installation the hood insulation panel
1. Open the hood. 2. Disconnect the windshield washer hoses. 3. Disconnect the wires from the underhood lamp, pull them out, and pass them under the insulating panel. 4....

Removal and installation the radiator grille
1. Open the hood. 2. Unscrew the two screws securing the central section of the grille. 3. Remove the headlight washer nozzles by pulling them out of the holders. 4....

Removal and installation the fuel filler neck lock cylinder
1. Open the fuel filler cap. Remove the key. 2. Press the lock cylinder with your thumb in the area of the keyhole. With your other hand, insert a screwdriver into the...

Removal and installation the hatch cover
1. Open the hatch. 2. Unscrew the four screws and ten self-tapping screws securing the hatch frame (1 – adhesive tape, 2 – frame securing screws). 3. To protect the...

Removal and installation of windshield and fixed glass
The windshield, rear and rear side windows are installed and sealed with a special adhesive. To remove and install the glass, you must contact a specialized service...

Removal and installation decorative windshield trims
Attention! To install decorative trims on the door glass frame, you must use a rivet gun. 1. Open the front doors. Remove the gutters. 2. Drill out five rivets securing...

Removal and installation decorative trims on the rear door glass
1. Open the back door. 2. Unscrew the two nuts securing the upper trim and the two screws securing the lower trim. Close the rear door. 3. Press down the lower trim...

Removal and installation of emblems
The emblem on the hood, the inscription on the trunk door and all other signs are attached with glue. They can be separated with a thin cord, the reciprocating movements...

Adjusting the front bumper installation height
Adjusting the front bumper installation height 1 – clamp nut, 2 – locking bolt, 3 – threaded sleeve, 4 – bumper, 5 – adjusting bolt The front bumper installation height...

Removal and installation bumpers
1. Raise the front or rear of the vehicle accordingly and secure it on stands. Front bumper 2. Disconnect the side clips (arrow) by turning them 90°. Release the cross...

Removal and installation bumper pads
Models up to mid 1990 (all models except GHIA) 1. Remove the bumper. 2. Remove the old trim from the bumper. 3. Clean the adhesive residue from the bumper trim groove....

Removal and installation the front spoiler
Attention! To install the spoiler, you must use a rivet gun. 1. Raise and secure the front of the vehicle. 2. Drill out two rivets on both sides of the spoiler that...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Fusion
Scorpio 1
Scorpio 2
Sierra