Contents: Front bumper ↳ Rear bumper ↳
1. Raise the front or rear of the vehicle accordingly and secure it on stands.
Front bumper
2. Disconnect the side clips (arrow) by turning them 90°. Release the cross stops by pulling them away from the bumper.
3. Using a Torx wrench, completely unscrew the locking bolts, then use a 24mm socket to unscrew the adjusting bolts.
4. Pull the bumper forward away from the vehicle and remove it.
5. Installation is performed in the reverse order of removal. It is necessary to adjust the bumper installation height.
Rear bumper
6. Disconnect the side clamps by turning them 90°.
7. Remove the two Torx screws securing the rear bumper to the supports.
8. Disconnect the license plate light wires and remove them from the bumper.
9. Pull the bumper back away from the car and remove it.
10. Installation is carried out in the reverse order of removal.
11. Adjust the support brackets so that the distance between the bumper and the top surface of the bracket is 111 mm.
12. Lower the car.