Contents: Removal ↳ Installation ↳
Removal
All cars
1. Remove the dust cap.
Cars with rear disc brakes
2. Remove the rear brake disc. For additional information, refer to Section 206-04.
3.
CAUTION: To avoid damaging the wheel hub nut, use a socket wrench when removing it.
Remove the wheel hub.
- Remove the wheel hub mounting nut.
Cars with rear drum brakes
4.
CAUTION: The wheel hub removal described in this procedure is intended to allow installation of new wheel bearings, not to access brake system components.
Remove the wheel and tire assembly. Refer to Section 204-04 for additional information.
5. Release the parking brake.
6.
CAUTION: To avoid damaging the wheel hub nut, use a socket wrench when removing it.
Remove the wheel hub.
- Remove the wheel hub mounting nut.
Installation
Cars with rear drum brakes
1.
CAUTION: Do not strike the wheel speed sensor ring.
CAUTION: Make sure the wheel speed sensor ring is clean.
CAUTION: Do not allow any contact between the wheel speed sensor ring and the magnetic surface.
CAUTION: The wheel hub nut can be reused four times, mark the wheel hub nut.
NOTE: Do not fully tighten the wheel hub nut at this stage.
Install the wheel hub.
2.
CAUTION: To avoid damaging the bearing, turn the brake drum 10 times in the opposite direction when tightening the wheel hub nut.
Tighten the wheel hub mounting nut.
3. The parking brake should be applied.
4. Install the wheel and tire assembly. Refer to Section 206-04 for additional information.
Cars with rear disc brakes
5.
CAUTION: Do not strike the wheel speed sensor ring.
CAUTION: Make sure the wheel speed sensor ring is clean.
CAUTION: Do not allow any contact between the wheel speed sensor ring and the magnetic surface.
CAUTION: The wheel hub nut can be reused four times, mark the wheel hub nut.
NOTE: Do not fully tighten the wheel hub nut at this stage.
Install the wheel hub.
6.
CAUTION: To avoid damaging the bearing, turn the brake drum 10 times in the opposite direction when tightening the wheel hub nut.
Tighten the wheel hub mounting nut.
7. Install the rear brake disc. For additional information, refer to Section 206-04.
All cars
8.
NOTE: If the dust cap is damaged during removal, a new dust cap must be installed.
Install the dust cap.