Contents: Removal ↳ Installation ↳
Special tool
 | Bearing installation tool for axle shaft 205-146 (T80T-4000N) |
 | Steering Gear Oil Seal Installer 211-140 (T88C-3504-DH) |
 | Device for installing the holder of the moisture-proof seal 204-323 |
 | Adapter for 303-224 (handle) 205-153 (T80T-4000-W) |
 | PTO 308-432 Dust Flange Installation Tool |
Removal
All cars
1. Remove the wheel hub.
Cars with anti-lock braking system
2. Remove the wheel speed sensor ring and discard it as no longer needed.
All cars
3. Using a suitable screwdriver, remove the moisture seal holder (if equipped).
4. Remove the retaining ring.
5. Using a special tool, remove the wheel bearing.
6.
NOTE: The new wheel knuckle comes with a weather seal installed.
Remove the wheel knuckle and discard it as no longer needed.
Installation
All cars
1. Using the special tool, install the new wheel bearing.
2. Install the retaining ring.
3. Using the special tools, install the moisture seal holder.
Cars with anti-lock braking system
4.
CAUTION: Do not strike the wheel speed sensor ring.
CAUTION: Make sure the wheel speed sensor ring is clean.
CAUTION: Do not allow any contact between the wheel speed sensor ring and the magnetic surface.
NOTE: Install a new wheel speed sensor ring.
Using the special tool, install the wheel speed sensor ring.
All cars
5.
NOTE: Install a new wheel knuckle.
Install the wheel knuckle.
6. Install the wheel hub. For more information, refer to the Wheel Hub chapter in this section.
Content was created using data from this website FordBook