Manual gearbox MT285 car Ford Focus 1

MT285 Manual Transmission Specifications
Lubricants, fluids, sealants and adhesives Position Specification Transmission Fluid for Manual Transmission WSD-M2C200-C Fill volumes l Transmission Fluid for Manual...

Description and principle of operation of MT285
Elements of a mechanical gearbox in a block with a drive axle Pos. Spare Part No Name 1 – input shaft 2 – Output shaft 1 3 – Output shaft 2 4 – Differential 5 –...

Draining and refilling transmission fluid
Name Specification Transmission Fluid for Manual Transmission WSD-M2C200-C 1. Raise and support the vehicle. See Section 100-02 for more information. 2. Remove the drain...

Consolidation of the left semiaxis — removal and installation
Special tool Drive axle puller 204-226 (16-092) Adapter for 204-226 204-226-01 (16-092-01) Hammer with movable head 205-047 (15-011) Adapter for 205-342 205-342-02...

Consolidation of the right semiaxis — removal and installation
Special tool Axle shaft oil seal remover 308-208 (16-074) Crankcase Oil Seal Installer 307-028 (17-002) Withdrawal 1. Remove the right axle shaft and intermediate shaft....

Transmission in a block with a driving axle — removal
Special tool Axle puller 204-226 (16-092) Adapter for 204-226 204-226-01 (16-092-01) Hammer with moving hammer 205-047 (15-011) Engine support beam 303-290A (21-140)...

Transmission in a block with a driving axle — installation
Special tool Engine support beam 303-290A (21-140) Adapter for 303-290A (21-140) 303-290-01 (21-140-01) Adapter for 303-290A (21-140) 303-290-02 (21-140-02) Adapter for...

External controls MT285
Torque Specifications Position Nm Pound-foot Pound inch Bolts of fastening of the lever mechanism of a gear change 10 - 89 Screws of fastening of the top section of the...

Diagnosis and testing of external controls
Inspection and verification 1. Check the validity of the customer's complaint. 2. Perform a visual check for obvious signs of mechanical damage. Visual Inspection Table...

Lever gear shift mechanism — removal and installation
Withdrawal 1. Remove the boot and shift knob. 2. Remove the floor console. See Section 501-12 for more information. 3. Remove nuts of fastening of the lever mechanism of...

Gearshift cables — removal and installation
Withdrawal 1. Remove the air filter. See Section 303-12 for more information. 2. Disconnect the shift cables from the transaxle. 1. Disconnect the shift cable (white...

Gear lever — disassembly and assembly
Disassembly 1. Remove the floor console. See Section 501-12 for more information. 2. Move the shift lever to third gear. 3. Disconnect the shift cable from the shift...