Draining and filling transmission fluid

Name	Specification
Transmission fluid for manual transmission	WSD-M2C200-C

1. Raise and support the vehicle. Refer to Section 100-02 for additional information.

2. Remove the drain plug from the transmission in the block with the drive axle.

• Allow the oil to drain into a suitable container.
• Discard the seal.

3.

NOTE: Install a new drain plug seal.

NOTE: Clean the drain plug threads.

Install the drain plug.



4. Remove the filler plug of the gearbox in the block with the drive axle.



5.

CAUTION: The transmission fluid capacity of the transaxle is 1.7 L. When adding fluid to the transaxle, add approximately 1.5 L - 1.6 L.

Having placed the vehicle on a flat horizontal surface, fill the gearbox in the block with the drive axle to a level below the lower edge of the filler plug channel with the working fluid for the manual transmission.



6. Install the gearbox filler plug in the block with the drive axle.



7. Lower the vehicle.