Lighting, light and sound signaling Ford Focus Turnier 1

External lighting equipment
The Focus's exterior lighting includes headlamps, fog lamps, tail lamps and brake lamps, reversing lamps, rear fog lamps, and direction indicator and number plate lamps....

Adjusting the light range
Every Focus is factory-fitted with a headlight adjustment system. This allows the beam to be precisely adjusted to the load - oncoming traffic is never blinded. The beam...

Replacing headlight bulbs
The parking light, high beam and low beam bulbs are located in the headlight housing. You do not need to remove the headlights to replace them. Open the hood and remove...

Replacing bulbs in fog lights
Disconnect the bayonet lock on the back of the fog light. Remove the headlight assembly. Remove the protective cap and disconnect the connector. Disconnect the wire clip...

Replacing the bulbs in the front turn signals
Remove the mounting screws with a suitable screwdriver. Pull the lamp unit forward. Turn the lamp holder to the left until it stops and remove it. Remove the lamp from...

Replacing side turn signal bulbs
Press the turn signal lamp upward against the spring pressure. Secure the lamp holder, turn the lamp shade to the left and remove. Remove the lamp from the socket....

Replacing the bulbs in the rear lights (hatchback)
Open the back cover and unscrew the wing nut of the corresponding lamp housing. Remove the rear light cover using a Phillips screwdriver. Carefully remove the lamp...

Replacing the bulbs in the reversing light and fog light
Model with a beveled back Press down the mounting plate on the back of the case. Press the body outward. Disconnect the connector. Turn the lamp holder all the way to...

Replacing the bulbs in the rear lights (with a stepped rear section)
Open the back cover - unscrew the three wing nuts in the lamp housing. Carefully remove the lamp housing from the vehicle body. Lift the plug tabs of the lamp holder and...

Replacing the bulbs in the rear lights (Turnier)
Open the back cover - unscrew both mounting screws with a Phillips screwdriver. Carefully remove the lamp housing from the vehicle body. Lift the plug tabs of the lamp...

Replacing the spotlight bulb in the license plate light
Pry out the lamp assembly with a flat-head screwdriver. Remove the spotlight from the socket. Insert the new spotlight lamp, secure the lamp block. Replacing the...

Replacing bulbs in additional brake light (hatchback)
Unscrew the lamp shade with a Torx screwdriver. Detach the lamp holder from the reflector. Remove the defective lamp(s) from the socket. Replacing a bulb in an...

Replacing the bulbs in the additional brake light (sedan)
Open the back cover. Use a screwdriver to remove the mounting pins and cover. Disconnect the lamp holder and remove the lamp(s) from the socket. Insert new lamp(s),...

Replacing interior lighting bulbs
Replacing spotlights in interior lights Turn off the interior light. Press the light with a flat screwdriver from the side opposite the switch. Front light: Replace the...

Temporary headlight adjustment
If you are in a hurry and cannot adjust your headlights properly, temporarily use the following aids: The fuel tank must be well filled. Otherwise, put some ballast in...

Signaling equipment
Your Focus's signalling equipment is an important tool for reliably informing other road users of your driving intentions. For example, if you want to change direction,...

Help with alarm malfunctions
Help with faulty hazard warning lights and direction indicators Help with brake light malfunctions

Dismounting the alarm horn of the beep
Dismantling Apply the handbrake, additionally secure the rear axle by placing a wedge underneath. Securely lift the left front part of the car. Disconnect the wire...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Focus 2

Focus Turnier 1
Focus 1