Replacing headlight bulbs (Focus Turnier 1)

The parking light, high beam and low beam bulbs are located in the headlight housing. You do not need to remove the headlights to replace them. Open the hood and remove the locking cap on the corresponding lamp block. Important: never hold the halogen bulb by the glass bulb - only by the socket. Use spare bulbs with an ultraviolet filter only.

Stages of work

Turn off the lights and ignition.

Open the hood.

Press down the latch on the protective cap on the back of the headlight and remove the cap.

Low/high beam

Disconnect the lamp connector, fold back the wire clip on the side and remove the lamp from the socket.

Insert a new bulb, connect, close the headlight.

Parking light

Turn the bulb holder to the right and remove it from the headlight.

Remove the lamp from the socket.

Insert the bulb, connect, close the headlight.

After each lamp replacement, check the headlight adjustment

Since the reflector may shift when replacing the bulbs in the headlights, you should park the car in front of a dark wall before replacing the bulbs and mark the light cone of the working bulbs on the wall with chalk. After replacing, compare the light reflection with the marking. If the reflector is shifted, it is best to adjust the light in a specialized workshop using an optical headlight adjustment device.

(The original version can be found on the website: fordbook.ru)