Car engine ignition system Ford Focus 1

Ignition system specifications 1.4/1.6 Zetec-SE
Tightening torque specification Name Nm pound-foot pound-inch Ignition Coil Bolts 6 - 53 Engine cover 6 - 53

Description and operating principle of the ignition system 1.4/1.6 Zetec-SE
Engine ignition system Pos. Spare Part No Name 1 Spark plug wires 2 Ignition coil 3 Spark plugs The crankshaft position sensor signal is the basis for ignition timing...

Diagnostics and testing of the ignition system 1.4/1.6 Zetec-SE
Inspection and verification 1. Check the validity of the customer's complaint by using the system. 2. Visually inspect for obvious signs of mechanical and electrical...

Ignition Coil Block 1.4/1.6 Zetec-SE
Removal 1. Disconnect the spark plug wires from the ignition coil. 2. Disconnect the ignition coil electrical connector. 3. Remove the ignition coil. Installation 1....

Spark plug wires 1.4/1.6 Zetec-SE
Special tool Spark plug connector pliers. 303 - 622 (21 - 226) Removal 1. Disconnect the fuel lines from the engine cover. 2. Remove the engine cover. 3. CAUTION: When...

Ignition system specifications 1.8/2.0/1.6 Zetec-E
Tightening torque specification Name Nm pound-foot pound-inch Ignition Coil Bolts 6 - 53 Ignition Coil Bracket Bolts 20 15 - EGR Pipe Bracket Bolts 9 - 80

Description and operating principle of the ignition system 1.8/2.0/1.6 Zetec-E
Engine ignition system Pos. Spare Part No Name 1 Spark plug wires 2 Ignition coil 3 Ignition coil bracket 4 Spark plugs The crankshaft position sensor signal is the...

Diagnostics and testing of ignition system 1.8/2.0/1.6 Zetec-E
Common equipment: Worldwide Diagnostic System (WDS). Inspection and verification 1. Check the customer complaint. 2. Visually inspect for obvious signs of electrical...

Ignition Coil Block 1.8/2.0/1.6 Zetec-E
Removal 1. Remove the ignition coil assembly cover (if equipped). 1. Disconnect the clamps. 2. Release the coolant line from the clamp. 2. Disconnect the spark plug...

Ignition coil bracket 1.8/2.0/1.6 Zetec-E
Removal 1. Remove the ignition coil. For more information, refer to the Ignition Coil Assembly chapter in this section. 2. Remove the audio block noise suppressor. 1....

Glow Plug System Specifications (1.8L Diesel)
Tightening torque specification Name Nm pound-foot pound-inch Glow plug 15 11 - Glow Plug Electrical Connector Fastening Nut 2 - 18 Glow Plug Wire Connector Fastening...

Description and operating principle of the glow plug system (1.8L diesel)
Glow plug system Pos. Spare Part No Name 1 Glow plug indicator light 2 Glow Plug Relay 3 Glow plug wire 4 Glow Plug Electrical Connector Fastening Nut 5 Glow plug Glow...

Diagnostics and testing of glow plug system (1.8L diesel)
Inspection and verification 1. Check the customer complaint. 2. Visually inspect for obvious signs of mechanical or electrical damage. Visual inspection table Electrical...

Glow Plug Wire (1.8L Diesel)
Removal 1. Remove the top engine cover. 2. Disconnect the electrical connector of the glow plug wire. 3. Disconnect the glow plug wire terminal block. 4. Disconnect the...

Description and operating principle of the ignition system (Duratec 8V 1.6L)
Tightening torque specification Name Nm pound-foot pound-inch Ignition coil unit mounting screws 6 - 53 Spark plugs 15 11 - Engine ignition system Pos. Spare Part No...

Diagnostics and testing of the ignition system (Duratec 8V 1.6L)
Common equipment: Worldwide Diagnostic System (WDS). Inspection and verification 1. Check the customer complaint. 2. Visually inspect for obvious signs of electrical...