Car windscreen wipers and washers Ford Focus 1
Windscreen Wiper Specifications
Windshield wiper arm angle relative to windshield (LHD) Corner both sides -2° Windshield wiper arm angle relative to windshield (RHD) Corner both sides 2° Tightening...
Windshield wiper arm angle relative to windshield (LHD) Corner both sides -2° Windshield wiper arm angle relative to windshield (RHD) Corner both sides 2° Tightening...
Description and operating principle of windshield wipers
All functions are activated using a multi-function switch controlled by the windscreen wiper lever, which is located on the right side of the steering column. Windshield...
All functions are activated using a multi-function switch controlled by the windscreen wiper lever, which is located on the right side of the steering column. Windshield...
Diagnostics and testing of windshield wipers (cars up to 08.2001)
Inspection and verification 1. Check the validity of the customer's complaint. 2. Visually inspect for obvious signs of mechanical or electrical damage. Visual...
Inspection and verification 1. Check the validity of the customer's complaint. 2. Visually inspect for obvious signs of mechanical or electrical damage. Visual...
Pinpoint tests of windscreen wipers (cars up to 08.2001)
PINPOINT TEST A: WINDSHIELD WIPERS DO NOT WORK STATES DETAILS/RESULTS/ACTIONS A1: CHECK FUSE F55 1 Enter the OFF position. 2 CHECK Fuse F55 (CJB). 3 CHECK FUSE F55 (20A)...
PINPOINT TEST A: WINDSHIELD WIPERS DO NOT WORK STATES DETAILS/RESULTS/ACTIONS A1: CHECK FUSE F55 1 Enter the OFF position. 2 CHECK Fuse F55 (CJB). 3 CHECK FUSE F55 (20A)...
Checking windshield wiper elements (vehicles up to 08.2001)
Windshield wiper motor Turn off the ignition Disconnect the connector. Using the connecting wire, prepare the testing procedure according to the following description....
Windshield wiper motor Turn off the ignition Disconnect the connector. Using the connecting wire, prepare the testing procedure according to the following description....
Diagnostics and testing of windshield wipers (cars after 08.2001)
Special tool Digital Multimeter 105-R0051 or equivalent Electric Probe Kit 29-011A Inspection and verification 1. Check the validity of the customer's complaint. 2....
Special tool Digital Multimeter 105-R0051 or equivalent Electric Probe Kit 29-011A Inspection and verification 1. Check the validity of the customer's complaint. 2....
Pinpoint tests of windscreen wipers (cars after 08.2001)
PINPOINT TEST K: WINDSHIELD WIPERS DO NOT WORK STATES DETAILS/RESULTS/ACTIONS K1: CHECK FUSE F56 (CJB) 1 Enter the OFF position. 2 CHECK Fuse F56 (CJB). 3 CHECK FUSE F56...
PINPOINT TEST K: WINDSHIELD WIPERS DO NOT WORK STATES DETAILS/RESULTS/ACTIONS K1: CHECK FUSE F56 (CJB) 1 Enter the OFF position. 2 CHECK Fuse F56 (CJB). 3 CHECK FUSE F56...
Checking windshield wiper elements (cars after 08.2001)
Windshield wiper motor Turn off the ignition. Disconnect the connector. Using the connecting wire, prepare the testing procedure according to the following description....
Windshield wiper motor Turn off the ignition. Disconnect the connector. Using the connecting wire, prepare the testing procedure according to the following description....
Adjusting the windshield wiper blades and arms
Special tool Windscreen wiper arm alignment tool 501-027 (32-006) Adjustment 1. WARNING: Make sure that the wiper motor is in the non-working position. Remove the wiper...
Special tool Windscreen wiper arm alignment tool 501-027 (32-006) Adjustment 1. WARNING: Make sure that the wiper motor is in the non-working position. Remove the wiper...
Windshield wiper motor — removal and installation
Removal 1. NOTE: Make sure the windshield wiper motor is in the off position. Remove the hood panel. For additional information, refer to Section 501-02. 2. Remove the...
Removal 1. NOTE: Make sure the windshield wiper motor is in the off position. Remove the hood panel. For additional information, refer to Section 501-02. 2. Remove the...
Rear Window Wiper Motor — Removal and Installation
Removal CAUTION: Disconnect the battery ground cable. Refer to Section 414-01 for additional information. 1. NOTE: Make sure the wiper motor is in the off position....
Removal CAUTION: Disconnect the battery ground cable. Refer to Section 414-01 for additional information. 1. NOTE: Make sure the wiper motor is in the off position....
Windshield washer pump and reservoir
Removal All cars 1. Remove the windshield washer reservoir filler neck. 2. Raise and support the vehicle. Refer to Section 100-02 for additional information. 3. Remove...
Removal All cars 1. Remove the windshield washer reservoir filler neck. 2. Raise and support the vehicle. Refer to Section 100-02 for additional information. 3. Remove...
This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
See other similar sections for Ford cars:
• Electrical equipment: Windshield wipers and washers Ford Mondeo 1 (1993-1996)
• Electrical equipment: Windshield wipers and washers Ford Scorpio 2 (1994-1998)
• Electrical equipment: Windshield wipers and washers Ford Mondeo 1 (1993-1996)
• Electrical equipment: Windshield wipers and washers Ford Scorpio 2 (1994-1998)
Focus 2
Focus Turnier 1
Focus 1
- General information
- Vehicle device
- Owner's manual
- Faults en route
- Maintenance
- First maintenance
- Second maintenance
- Applications
- Consumables and spare parts
- Auto mechanic tips
- Power unit
- Engine repair
- Engine seal parts
- Cooling system
- Exhaust system
- Supply system
- Clutch
- Car gearbox
- Front wheel drives
- Chassis
- Front suspension
- Rear suspension
- Steering
- Brake system
- Wheels and tires
- Body and coating
- Body elements
- Side doors
- Tailgate
- Salon elements
- Safety system
- Windshield wipers and washers
- Body Care
- Electrical equipment
- Instruments and motors
- Battery and alternator
- Egnition lock
- Engine management
- Headlights and lighting
- Switches and sensors
- Schematic diagrams
Focus Turnier 1
- General information
- Introduction to guide
- Car care
- Power unit
- Engine repair
- Lubrication system
- Cooling system
- Fuel injection (gasoline)
- Fuel injection (diesel)
- Ignition system
- Power and exhaust system
- Transmission
- Clutch and drive shafts
- Mechanical gearbox
- Automatic gearbox
- Chassis
- Car suspension
- Steering
- Wheels and tires
- Brake system
- Body
- Exterior
- Interior
- Heating and ventilation
- Electrical equipment
- Equipment and devices
- Lighting and signaling
- Power devices
- Electrical circuits
Focus 1
- General information
- Using the manual
- Identification codes
- Power unit
- Engine
- Engine 1.4/1.6 Zetec-SE
- Engine 1.6/1.8/2.0 Zetec-E
- Engine Duratec ST 2.0 l
- Engine Duratec 8V 1.6 l
- Diesel engine 1.8 l
- Engine cooling
- Fuel supply
- Accessory drive
- Launch system
- Ignition system
- Air and vapor
- Engine management
- Exhaust toxicity
- Exhaust system
- Automatic gearbox
- Clutch
- Mechanical gearbox iB5
- Mechanical gearbox MTX-75
- Mechanical gearbox MT285
- Chassis
- Front suspension
- Rear suspension
- Wheels and tires
- Front axle axles
- Brake system
- Hydraulic brake
- Anti-lock braking system
- Steering
- Body and coating
- Body panels
- Body elements
- Salon elements
- Glass, frames and mechanisms
- Windshield wipers and washers
- Car sunroof
- Seat belts
- Body repairs
- Back elements
- Electrical equipment
- Climate control
- Heating and ventilation
- Instruments and control lamps
- Battery and alternator
- Audio system
- Headlights and lighting
- Power distribution
- Electronic Function Group