Windshield washer pump and reservoir (Focus 1)

Removal

All cars

1. Remove the windshield washer reservoir filler neck.



2. Raise and support the vehicle. Refer to Section 100-02 for additional information.

3. Remove the right fender splash guard (wheel shown removed for clarity).



4. Remove the windshield washer reservoir.

• Disconnect the electrical connectors.
• Pull back the hoses.

5. Remove the windshield washer pump with rubber gasket (shown with reservoir installed).

• 1. Disconnect the electrical connector.
• 2. Disconnect the hoses.
• 3. Remove the pump.

Cars with headlight washer system

6. Remove the headlight washer pump and rubber seal.

• 1. Disconnect the electrical connector.
• 2. Disconnect the hoses.
• 3. Remove the pump.

Installation

1.

NOTE: Procedure to be used if the washer system develops a fault where water leaks from the filled washer reservoir during sudden braking or acceleration.

Install the additional cap over the rear tank vent line.

• 1. Front ventilation duct
• 2. Rear ventilation duct
• 3. Additional cap

2.

NOTE: When installing the tank, it is necessary to insert the filler neck using Vaseline.

Install the elements back in place in reverse order.

(The original version can be found on the website: FORDBOOK)