Rear window washer pump: Unscrew the upper plastic screw securing the side trim of the luggage compartment and remove the side jack.
Windscreen or headlight lens washer pump: disconnect the multi-pin plug connector of the windscreen washer pump "D" or the headlight lens washer pump "C", respectively. A - mounting screws, B - washer fluid level indicator sensor.
Figure 1: Window glass only washing system.
Figure 2: Window glass/headlamp lens washer system.
Rear window washer pump: disconnect the multi-pin connector of the rear window washer pump "C" A - filler pipe, B - mounting screws.
Connect a voltage measuring device to the plug connector. Turn on the ignition and apply voltage to the pump via the washer system switch. If the pump did not work, but voltage is supplied, then the pump must be replaced. If voltage is not supplied, the electrical wires should be checked in accordance with the electrical diagram. A test lamp can be used to perform this check
To check the headlight lens washer pump, in addition to turning on the washer system, you must also turn on the low beam. If voltage is supplied, the pump must be replaced. If voltage is not supplied, the electrical wires must be checked in accordance with the electrical diagram. A test lamp can also be used to perform this check.
(For more information, please visit the website: www.fordbook.ru)