Car steering Ford Scorpio 2

Description of the steering design
1 - hydraulic booster compensation tank 2 - steering column 3 - cardan joint 4 - steering mechanism 5 - steering rod end 6 - oil cooler 7 - hydraulic switch 8 - power...

Safety precautions when handling an airbag
Before removing the airbag assembly, disconnect the battery ground (-) wire and insulate the battery negative (-) strip. Then wait at least 15 minutes, otherwise the...

Removal and installation the steering wheel
Safety Instructions: Be sure to read the chapter " Safety precautions when handling an airbag ". Removal Important: Disconnect the battery ground (-) cable with the...

Adjusting the position of the steering wheel
The position of the steering wheel can be adjusted if, when the vehicle is moving in a straight line, it is turned from the middle position by an angle of no more than...

Removal and installation the tie rod end
Removal Loosen the wheel nuts on the vehicle while it is parked on the platform. Mark the position of the wheel on the hub with paint. This will allow the balanced wheel...

Removal and installation the steering gear bellows
Removal Remove the tie rod end. Press the projections of the outer fastening clamp with pliers and remove the clamp. Loosen the inner clamp or cut it with side cutters...

Power steering pump (petrol, up to 8/94)
When refilling or filling the hydraulic system, use only automatic transmission fluid (ATE) that meets FORD specification ESPM-2C-166H. Caution: Do not shake the...

Power steering pump (petrol, since 9/94)
Removal Disconnect the negative (-) battery cable. Caution: When the battery is disconnected, the contents of electronic memory devices, such as engine fault codes or...

Power steering pump (diesel)
Removal Disconnect the negative (-) battery cable. Caution: When the battery is disconnected, the contents of electronic memory devices, such as engine fault codes or...

Bleeding the power steering hydraulic system
Air in the hydraulic system will cause the power steering to fail. Air can enter the hydraulic system if it has been opened, or if a leak has caused the fluid level in...