Car automatic transmission Ford Sierra

Automatic transmission Ford C 3 — design description
Ford C 3 Automatic Transmission 1 - centrifugal regulator, 2 - parking lock mechanism ratchet (Parking), 3 - one-way clutch, 4 - rear planetary gear brake band, 5 -...

Automatic transmission specifications
Control size of the hydrokinetic transmission depth A = 10 mm The Ford C 3 automatic transmission has three forward gears and a reverse gear. When moving forward, the...

Automatic transmission maintenance and repair
Position "P" – parking ("Parking") In this position, the rear wheels are fixed. The automatic transmission is locked by a ratchet mechanism, preventing its shafts from...

Checking the gearbox oil level
The oil level should be checked immediately after stopping the vehicle, when the oil is warmed up, after driving to normal operating temperature (about 65°C). 1. Place...

Checking and cleaning the hydrokinetic transmission
1. Check the clearance between the turbine, the guide vane and the pump housing. Install a hydrokinetic transmission on the oil pump shaft and rotate it. There should be...

Checking oil pressure while the gearbox is running
1. Connect an oil pressure gauge with a female threaded end of the appropriate diameter to the gearbox housing. 2. Place the pressure gauge in the car so that its...

Hydrokinetic transmission engine overload test
The engine should only start with the gearshift lever in the "P" and "N" positions. With the engine idling, moving the gearshift lever to one of the "R", "D", "2" or "1"...

Checking the box while driving
At low speeds, with the accelerator pedal lightly depressed and the gearshift lever in position "D", the transmission should shift to 2nd gear at speeds below 45 km/h...

Adjusting the front planetary gear brake band
Adjusting the front planetary gear brake band A – adjusting bolt, B – lock nut, C – gear reduction lever, D – kick-down cable 1. Disconnect the cable (D) from the gear...

Removal and installation the gearbox
Removal 1. Place the vehicle over an inspection channel or on a lift and disconnect the ground wire from the battery. 2. From the engine compartment, unscrew the four...

Removal and installation the kick-down cable
Removal and installation 1. Disconnect the gear reduction cable from the carburetor lever and remove the casing from the holder. 2. Disconnect the gear reduction cable...

Removal and installation the engine safety start relay
1. Disconnect the electrical connector from the engine safety start relay. 2. Unscrew the relay mounting bolts and remove the relay together with the circular gasket. 3....

Box malfunctions and methods of their elimination
Cause Method of elimination The gear shift lever moves with difficulty or locks up. Check the gearshift lever. Check the gearshift mechanism and the gearshift lever...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Fusion
Scorpio 1
Scorpio 2
Sierra