Car engine power system Ford Scorpio 2

General information about the power supply system
The fuel system includes a fuel tank with a built-in sensor for the fuel level indicator, fuel lines, a fuel filter, a fuel pump and a carburetor or, accordingly, a fuel...

Safety and cleanliness when working with fuel supply systems
When working with fuel supply systems, it is necessary to strictly adhere to the stated safety and cleanliness rules. Safety instructions No open flames, no smoking, no...

Removal, installing and checking the fuel level sensor
The fuel level sensor, and in vehicles with a DOHC gasoline engine also the fuel pump, is located at the top of the fuel tank. The diesel engine has only a fuel level...

Removal and installation the fuel tank
The fuel tank with a capacity of 70 liters is made of sheet steel. The tank is located under the body bottom in the luggage compartment area. Attention: Strictly observe...

Removal and installation an electric fuel pump
Warning: No open flames, have a fire extinguisher ready and strictly follow safety regulations when working with fuel supply systems, see p. 54 . Carburetor engine The...

Removal, installation and testing of mechanical fuel pump
Carburetor engine The mechanical fuel pump is located on the left side of the cylinder block and is driven via an intermediate shaft. To check the fuel pump, it must be...

Removal and installation the air filter (cars up to 8/94)
Carburetor engine Removal Disconnect the air hose from the snorkel. OHC Engine: Disconnect the red vacuum hose from the tee on the bottom of the air filter. in the air...

Removal and installation the air filter (cars from 9/94)
Removal Disconnect plug connector "4" of the mass air flow meter. Move forward to detach the intake pipe "5". Petrol engine: remove 2 rubber loops "6". Diesel engine:...

Removal and installation the gas rod (cars from 9/94)
Caution: The gas rod is very sensitive to longitudinal fracture, so it must be handled very carefully during installation. One slight longitudinal fracture can later...

Adjusting the gas thrust
Please note: Depending on the model, the vehicle may be equipped with a wheel load control system. This system prevents uncontrolled wheel slippage when accelerating the...

Checking, removing and installing the fuel pump relay
Petrol engines since 9/92 If the fuel pump does not work (no operating noise is heard), check the power supply in the following order: the safety switch in the luggage...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Fusion
Scorpio 1
Scorpio 2
Sierra