Heating, ventilation and air conditioning of the car Ford Scorpio 1

Heating and ventilation system — general information

Fresh air enters the passenger compartment through the air intake grille in front of the windshield and is supplied by the heater fan to the passenger compartment. The...

Removal and installation the heater control unit

Cars manufactured before 04.1992 1. Remove the ground wire from the battery. Attention! This will erase the information in the electronic storage devices. Front block 2....

Removal and installation heater control cables

Front cables 1. Remove the heater control unit. 2. Remove the center console. 3. Remove the console bracket and the inner gear shift lever cover. 4. Remove the trim...

Removal and installation the heater

Cars manufactured before 04.1992 1. Remove the ground wire from the battery. Attention! This will erase the information in the electronic storage devices. 2. Relieve the...

Disassembly and assembly of the heater

1. Remove the heater. 2. Unscrew the two screws securing the heater radiator. Remove the radiator. 3. Use a screwdriver to release the clamps holding the housing halves...

Removal and installation of heater air ducts

1. Remove the ground wire from the battery. Attention! This will erase the information in the electronic storage devices. 2. Remove the top portion of the instrument...

Air Conditioner — General Information

In combination with a heater, the system allows you to create any temperature within reasonable limits in the car interior, as well as reduce the humidity of the air...

Air Conditioner Maintenance

Air Conditioning System Location 1 – thermostat, 2 – evaporator, 3 – expansion valve, 4 – compressor, 5 – compressor pulley, 6 – pressure sensor, 7 – sight glass, 8 –...

Compressor drive belt

1. Remove the ground wire from the battery. Attention! This will erase the information in the electronic storage devices. 2. On ONS engines, remove the radiator cooling...

Condenser Fan — Removal and Installation

Air Conditioning Vacuum Hoses (V6 Engine) 1. Remove the ground wire from the battery. Attention! This will erase the information in the electronic storage devices. 2....

Thermostat — removal and installation

1. Remove the ground wire from the battery. Attention! This will erase the information in the electronic storage devices. 2. Disconnect the vacuum hoses from the...

Heater water valve

The heater water valve is vacuum controlled. The valve is located on the right side of the engine compartment, near the bulkhead. 1. Drain the coolant from the cooling...




Fusion 
Scorpio 1 
Scorpio 2 
Sierra 
We use cookies to ensure the site works smoothly, remembers your settings, and is convenient for you 🍪