Contents: Front cables ↳ Rear cables ↳
Front cables
1. Remove the heater control unit.
2. Remove the center console.
3. Remove the console bracket and the inner gear shift lever cover.
4. Remove the trim under the front panel on both sides.
5. Remove the glove compartment cover.
6. Remove the radio.
7. Remove the ABS and EEC IV modules.
8. Remove the lower trim on the passenger side to access the heater housing.
9. Unscrew the two mounting screws and remove the cables from the heater.
10. Installation is carried out in the reverse order of removal.
Rear cables
1. Remove the center console.
2. Remove the front seat on the corresponding side.
3. Remove the rear seat cushion.
4. Unscrew the lower front belt mounting bolt.
5. Remove the front door seal mount by unscrewing the three screws.
6. Unscrew the front screw securing the rear door seal.
7. Unscrew the front carpet from the mount to provide access to the heater cable.
8. Release the cable and disconnect it from the throttle lever control unit.
9. Installation is carried out in the reverse order of removal.