Car windscreen wipers and washers Ford Mondeo 1

Replacing windshield wiper rubber
If the windshield is not cleaned well, the windshield wiper rubber should be replaced. Windshield wiper blades are sold as a set (rubber with a holder) and as separate...

Removing, installing and adjusting the windshield washer nozzle
Adjustment The spray direction of the nozzles can be adjusted with a needle if necessary. Windshield Nozzle Adjustment Diagram; dimensions are given in mm. 1 - Front...

Windscreen washer reservoir, pump and fluid level sensor
The front and rear window washers are supplied with fluid from a common supply tank located in front of the right front wheel. Depending on the direction of rotation of...

Front windshield wiper — design description
Front wiper: 1 - Windscreen wiper blade; 2 - Windscreen wiper arm; 3 - Hex nut; 4 - Spring washer; 5 - Flange bolt; 6 - Expansion washer; 7 - Rubber tip; 8 - Bushing; 9...

Removing and installing the front wiper motor
Removal Wet the windshield with water. Operate the windshield wiper mechanism for approximately two minutes and then turn off the windshield wiper switches. This will...

Removing and installing the windshield wiper mechanism
Removal Remove the windshield wiper arms, see item 23.5 . Remove the ventilation grille, see paragraph 17.5 . Press the mechanism with a fork wrench at three rotation...

Removing and installing the rear wiper motor
Removal Wet the rear window with water. Operate the rear window wiper for 2 minutes and turn it off with the wiper switch. This will set the wiper to the end position....

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Mondeo 4
Mondeo 3
Mondeo 2
Mondeo 1 and 2
Mondeo 1