Duratec VE Gasoline Engines Ford Mondeo 2

2.5-liter Duratec VE engine
This twin-block engine is made entirely of aluminum. Four overhead camshafts are driven by two control chains. Other features of this engine include electronic engine...

Removing and installing the left cylinder head cover
To remove the left cover, proceed as follows: - disconnect the wire from the negative terminal of the battery, observing all safety precautions (see section 1); - remove...

Removing and installing the right cylinder head cover
To remove the right cover, proceed as follows: - disconnect the wire from the negative terminal of the battery, observing all safety precautions (see section 1); -...

Removing and installing the upper intake manifold
Remove the upper intake manifold in the following order: - disconnect the wire from the negative terminal of the battery; Fig. 313. Upper intake manifold mounting...

Replacing camshaft sealing rings
A special tool is used to remove the belt pulley on the camshaft. In addition, before installation, it is necessary to warm up the belt pulley with an air heater....

Removing and installing the left exhaust manifold
Remove the left exhaust manifold in the following order: - disconnect the wire from the negative terminal of the battery and remove the engine cover; - disconnect the...

Removing and installing the right exhaust manifold
Remove the right exhaust manifold in the following order: - disconnect the wire from the negative terminal of the battery and remove the engine cover; - disconnect the...

Removing and installing the oil pan
Remove the oil pan in the following order: - Jack up the front of the car. If installed, remove the underbody protection sheet under the front of the car; - remove the...

Replacing the rear crankshaft seal ring
The transmission, engine flywheel, clutch or drive pulley (in an automatic transmission) must be removed if the O-ring needs to be replaced. To remove the ring, you need...

Disassembling the engine
The instructions given when describing the disassembly process of the 16-valve engine are also valid for this engine. See these instructions in Section 2 before...

Engine assembly
All instructions for assembling the 16-valve engine are also valid for the V6 engine. The following description assumes that all parts are prepared for assembly. When...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

See other similar sections for Ford cars:
• Power unit: Engine Duratec ST 2.0 l Ford Focus 1 (1998-2004)

Mondeo 4
Mondeo 3
Mondeo 2
Mondeo 1 and 2
Mondeo 1