Technical requirements and tightening torques Designation MTX-75 Gear ratios of the gearbox gear set A gear set B First gear 3.417:1 3.231:1 Second gear 2.136:1 2.136:1 Third gear 1.448:1 1.483:1 Fourth gear 1.028:1...
General information about manual transmission The vehicles in this manual are equipped with a five-speed manual transmission or a four-speed automatic transmission. This chapter provides information about the manual...
Adjusting the gear shift mechanism Note: You will need a special device Ford7 6-073. It is a ring with a slot that locks the gearshift lever in neutral during adjustment. If you do not have such a device,...
Gear shift mechanism and lever Gear shift lever mechanism (models produced before 1997) Removal 1. Remove the central console (Chapter 11). See Fig. 3.1. 2. Apply the parking brake, raise the front... There are 1 a comment
Removing and installing the speedometer drive gear Removal 1. The gear can be accessed from above or below. To remove it from above, you need access from the top of the engine. To do this, you need to remove the air flow...
Replacing the cuff 1. Oil leaks are often caused by wear or damage to the differential seals and/or the selector shaft seal, as well as the speedometer drive pinion seal. Replacing these...
Removing and installing the reverse light switch Removal 1. Remove the air cleaner and air flow meter ( chapter 4 ). 2. Disconnect the wiring going to the switch located on top of the transmission. 3. Remove the bolts...
Removing and installing manual transmission Note: Read the entire procedure, especially the instructions regarding lifting equipment. Depending on your means, you may want to remove the powerhead first, then use a...
Manual Transmission Repair 1. Manual transmission repair is a difficult job for a DIYer. The repair requires removing and reinstalling many small parts. Numerous gaps must be accurately measured... There are 1 a comment