Removing and installing the reverse light switch (Mondeo 1 and 2)

Removal

1. Remove the air cleaner and air flow meter (chapter 4).

2. Disconnect the wiring going to the switch located on top of the transmission.

3. Remove the bolts and switch from the transmission housing cover.

Installation

4. Installation - in the reverse order of removal.

This publication was borrowed from the website [FordBook.ru]

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article reviewed: Yaroslav Gorbunov

« Previous articles
Replacing the cuff
Removing and installing the speedometer drive gear
Gear shift mechanism and lever
Adjusting the gear shift mechanism
General information about manual transmission

Next articles »
Removing and installing manual transmission
Manual Transmission Repair

See other similar articles for Ford cars:
• Removing and installing the ignition switch (lock) Ford Focus 2 (2004-2010)
• Removing and installing the brake light switch Ford Escort 4 (1986-1990)
• Removing and installing the coolant temperature sensor Ford Fiesta 2 (1983-1989)
• Brake Light Switch — Removal and Installation Ford Taurus 1 and 2 (1986-1994)
• Checking and replacing the reverse light switch Ford Fusion (2002-2012)
• Reverse Light Switch — removal and installation Ford Transit 2 (1986-2000, diesel)