Car battery and alternator Ford Mondeo 4

Removing and installing the battery
You will need: 10 and 12 mm wrenches (socket heads are more convenient). 1. Open the battery cover above the positive terminal, loosen the nut securing the wire to this...

Generator
Fig. 10.6. Generator parts: 1 – pulley mounting nut; 2 – pulley; 3 – front bearing pressure plate fastening screw; 4 – generator cover tightening bolt; 5 – drive side...

Removing and installing the generator
You will need: a 10 mm socket wrench and a 15 mm wrench. NOTE: Removal and installation of the alternator are shown using a vehicle with a 1.6L Duratec engine as an...

Checking the ignition system
WARNING: Your vehicle has a high energy microprocessor controlled ignition system (HEISS). Approximately 40,000 volts are applied to the high voltage wires. Although the...

Generator repair
The generator is a fairly complex and high-precision unit. Special equipment is required for its disassembly, defect detection and assembly. Therefore, if you do not...

Starter
Ford Mondeo cars are equipped with starters from Bosch. The starter is a DC electric motor with excitation from permanent magnets, with a planetary gearbox and an...

Removing and installing the starter
You will need: socket wrenches "10", "13". Place the vehicle on an inspection pit or lift. 1. Disconnect the wire from the negative terminal of the battery. 2. Unscrew...

Starter repair
Before disassembling the starter, make sure it is faulty by performing the following simple checks. 1. Using a screwdriver, check the ease of movement of the drive...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Mondeo 4
Mondeo 3
Mondeo 2
Mondeo 1 and 2
Mondeo 1