Vehicle lighting and electrical appliances Ford Mondeo 2

Checking the windshield wiper and alarm system

Turn on the ignition, operate the windshield wiper lever. Check the following: 1) does the windshield wiper move in both directions at the same speed, do the windshield...

Removing and installing the windshield wiper motor (front)

To remove the windshield wiper motor (front), proceed as follows: - turn the windshield wiper motor on and off; - remove the windshield wiper arms as described above; -...

Removing and installing the windshield wiper (front)

To remove and install the windshield wiper (front), proceed as follows: - perform the work described in the previous section, including removing the aerodynamic...

Replacing the wiper bearing

Fig. 294. Removing and installing the windshield wiper arm: 1 — nut; 2 - washer; 3 - windshield wiper lever; 4 — windshield wiper spindle; 5 - nut Before replacing the...

Removing and installing the windshield wiper motor (rear)

The procedure for work on hatchback and estate cars is different. Removal and installation of the windshield wiper motor (rear) for hatchback vehicles is carried out as...

Outdoor lighting

The outdoor lighting system includes the following elements: - headlights; - light switch; - a relay designed to switch between high and low beams; - high/low beam...

Replacing headlight bulbs

Replace headlight bulbs as follows: - disconnect the protective clamp from the back of the headlight and remove the trim; - disconnect the wire plug, fold back the...

Replacing parking light bulbs

These lamps are located next to the headlight lamps. Replace the parking light bulbs as follows: - remove the headlight and cover from the back to gain access to the...

Removing and installing headlights

Remove the headlights as follows: Fig. 296. Fastening the radiator grille - remove the radiator grille (its fastening is shown in Fig. 296); Fig. 297. Headlight mounting...

Headlight adjustment

A special optical device is used to adjust the headlights. The car should not be loaded during the check, the tire pressure should be normal. Before adjusting, rock the...

Control and measuring instruments

Coolant Temperature Warning Light As the engine warms up, the indicator needle moves toward the red zone. At elevated temperatures, the coolant boils. In this case, stop...

Electrical diagrams

Conventional symbols for electrical circuits A7 — ABS control unit A11 - radio receiver A30 - Instrument panel A30 (15) - tachometer A30 (7) — Left turn signal indicator...




Mondeo 4 
Mondeo 3 
Mondeo 2 
Mondeo 1 and 2 
Mondeo 1 
We use cookies to ensure the site works smoothly, remembers your settings, and is convenient for you 🍪