Car Gearbox Ford Mondeo 4

Transmission
Ford Mondeo cars are equipped with (depending on the type of engine used) manual gearboxes of the iB5, MTX-75, MMT6 or MT-66 models as standard. All manual gearboxes...

Changing the oil in a manual transmission or the working fluid in an automatic transmission
The design of gearboxes does not provide for replacement of oil (working fluid) throughout the entire service life of the vehicle. However, sometimes the need to change...

Replacing gearbox seals
You will need: a flat-blade screwdriver, a hammer, and a mandrel. 1. To replace the axle shaft seal, drain the oil (liquid) from the gearbox ( see Changing the oil in a...

Removing and installing the gearbox
The main faults that require removing the manual transmission from the vehicle to eliminate are as follows: – increased (compared to usual) noise; - difficult gear...

Replacing gearbox control cables
You will need a 10 mm wrench. To replace the manual transmission control cables, perform the following operations. 1. Remove the gearshift lever linkage ( see Removing...

Removing and installing the gearbox control lever linkage
To remove the backstage manual transmission gear, perform the following operations. 1. Remove the floor tunnel lining ( see Removing and installing floor tunnel lining...

Adjusting the gearbox control drive
The manual transmission control drive consists of two cables: gear selection and gear shifting, but only the gear selection cable is adjustable. You will need: a metal...

Checking the level of working fluid in the automatic transmission
The automatic transmission fluid level indicator (dipstick) is located near the engine compartment shield under the brake system reservoir. The lower part of the fluid...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Mondeo 4
Mondeo 3
Mondeo 2
Mondeo 1 and 2
Mondeo 1