Car steering Ford Mondeo 1 and 2

Removing and installing the steering wheel
Removing and installing the steering wheel
Warning: All models are equipped with an air bag. Follow the precautions given in Chapter 12. Removal 1. Disconnect the negative battery cable ( chapter 5 paragraph 1 )....

Removal, inspection and installation of the steering column
Removal, inspection and installation of the steering column
Warning: All models are equipped with an air bag. Follow the precautions given in Chapter 12. Removal 1. Disconnect the negative battery cable ( chapter 5 paragraph 1 )....

Removing and installing the steering column elastic coupling
Removing and installing the steering column elastic coupling
Removal 1. Disconnect the negative battery cable ( chapter 5 paragraph 1 ). 2. Turn the steering wheel to the straight-ahead position. Remove the ignition key. Then turn...

Power steering (4-cylinder)
Power steering (4-cylinder)
Removal 1. Remove the steering column flexible coupling ( paragraph 29 ). 2. Apply the handbrake, lift the front end and place it on supports. Remove both front wheels....

Power steering (6 cylinder)
Power steering (6 cylinder)
Removal 1. Disconnect the negative battery cable ( chapter 5 paragraph 1 ). 2. Loosen the clamp plate bolt securing the steering shaft to the flexible coupling. Turn the...

Replacing the rubber boots of the steering gear
Replacing the rubber boots of the steering gear
1. Remove the end piece and its lock nut from the transverse steering rod (paragraph 35). The end piece and rod must have marks for subsequent correct installation in...

Bleeding the hydraulic steering system
Bleeding the hydraulic steering system
1. If you have disconnected the hydraulic power steering system lines, you will need to bleed the air from the system after this. 2. The front wheels should be in the...

Removing and installing the hydraulic power steering pump
Removing and installing the hydraulic power steering pump
Removal 1. Disconnect the negative battery cable ( chapter 5 paragraph 1 ). 2. Disconnect the electrical connector of the hydraulic steering system pressure sensor (see...

Radiator of working fluid of the hydraulic system of steering
Radiator of working fluid of the hydraulic system of steering
Removal 1. Disconnect the negative battery cable ( chapter 5A ). 2. Apply the parking brake. Raise the front end and place it on supports. 3. The hose connections on the...

Replacing the tie rod end
Replacing the tie rod end
Removal 1. Apply the parking brake. Loosen the nuts of the corresponding wheel. Raise the front end and place it on supports. Remove the front wheel. 2. Use a wrench to...

Wheel alignment and steering angles
Wheel alignment and steering angles
1. Correct wheel alignment is essential for reliable steering operation and to prevent excessive tire wear. Perform the check when you are sure that the tire pressure is...

Steering tightening torques
Steering tightening torques
Tightening torques for connections Name Nm Steering gear input shaft clamp bolt in elastic coupling 28 Steering hydraulic system pipe fittings in the valve block 31...




Mondeo 4 
Mondeo 3 
Mondeo 2 
Mondeo 1 and 2 
Mondeo 1