- disconnect the wire from the negative terminal of the battery, observing all safety precautions (see section 1);
- remove the upper part of the intake manifold as described below;
Fig. 312. Spark plug connectors (lower arrows) and injection system wiring harness (left arrows)
- Disconnect the high-voltage wire connectors from the spark plugs (see Fig. 312). Press the injection system wire harness off the engine mount;
- unscrew the four ignition coil screws, remove the coil, disconnect the connector from the coil, press the wiring harness and unscrew the ground wire;
- unscrew the fastening clamp of the front and rear wiring harnesses from the cylinder head cover. In addition, you need to unscrew the cable shaft from the cover (2 screws);
- unscrew the cylinder head cover. In this case, it is necessary to perform a certain sequence of actions. Grasp the cover in the middle from the outside and then release it crosswise. Unscrew the two screws in the middle last. Remove the cover together with the gasket.
Installation is carried out in the reverse order. The instructions for installing the left cover also apply to this cover. All screws should be tightened to a torque of 6 Nm.
For more information, please visit the specified website (www.fordbook.ru)