Removal
1. Remove the wheel and tire assembly. Refer to Section 204-04 for additional information.
2. Set the suspension to the design height. Refer to Section 204-00 for additional information.
3. Disconnect the upper control arm from the wheel knuckle (station wagon shown).
4.
NOTE: To facilitate subsequent installation, mark the position of the upper arm.
Remove the upper control arm (station wagon shown).
Installation
All cars
NOTE: Final tightening of rear suspension components should be performed at the design suspension height.
1. Connect the upper control arm to the crossmember (station wagon shown).
2. Install the upper control arm (station wagon shown).
3. Lower the suspension out of the calculated height position.
3-, 4-, 5-door version
4. Connect the stabilizer bar to the rear lower arm.
All cars
5. Install the spring. For more information, refer to the Spring chapter in this section.
6. Install the wheel and tire assembly. Refer to Section 204-04 for additional information.
Visitor comments