Withdrawal
1. Remove the rear wheel and tire assembly. See Section 204-04 for more information.
2.
NOTE: When removing the left shock absorber, the exhaust system must be disconnected from the rear outboard support.
Disconnect the exhaust system from the rear outboard support.
3.
NOTE: When removing the left shock absorber, the exhaust heat shield must be removed.
Remove the exhaust system heat shield.
4. Using a transmission jack, support the lower control arm.
5. Turn out the top bolt of fastening of the shock-absorber (right side shown).
6. Remove shock absorber (right side shown).
Installation
1.
NOTE: The final tightening of the shock absorber lower mounting bolt should be done with the vehicle resting on its own wheels.
Install shock absorber (right side shown).
2. Install the upper shock absorber mounting bolt (right side shown).
3. Lower and remove the transmission jack.
4.
NOTE: After installing the left shock absorber, the exhaust system heat shield must be installed.
Install the exhaust heat shield.
5.
NOTE: After installing the left shock absorber, the exhaust system must be connected to the rear outboard support.
Connect the exhaust system to the rear suspension support.
6. Install the rear wheel and tire assembly. See Section 204-04 for more information.
7. Tighten the lower shock absorber mounting bolt (right side shown).
Visitor comments