Disassembly and assembly of the intermediate shaft gear block (Scorpio 1)

Disassembling the intermediate shaft gear block is not particularly difficult. Care should be taken not to lose the bearing needles and the spacers (front and rear) of the needle bearings. When assembling, carefully install the two spacers and coat the bearing needles with grease so that they do not fall out during the installation of the gear block shaft.

(The original post is on the web portal: fordbook)

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article reviewed: Herman Ostrovsky

« Previous articles
Assembly of the secondary shaft of the gearbox
Disassembling the secondary shaft of the gearbox
Gear shift mechanism — design description
Assembly of a manual gearbox
Disassembling a manual gearbox

Next articles »

See other similar articles for Ford cars:
• Intermediate shaft — removal and installation Ford Focus 1 (1998-2004)
• Removing and installing the intermediate shaft Ford Mondeo 2 (1997-2000)
• The device and inspection of the cylinder block Ford Escort 3 (1980-1985)
• Disassembling the secondary shaft of the box Ford Fiesta 2 (1983-1989)
• Intermediate shaft — removal and installation Ford Taurus 1 and 2 (1986-1994)
• Checking the universal joint and intermediate bearing of the… Ford Transit 2 (1986-2000, diesel)