1. To replace the axle shaft seal, drain the oil from the gearbox (see "Gearbox oil change").
2. Remove the front wheel drive from the side of the oil seal being replaced (see "Removal and installation front wheel drives").
3. Remove the seal with a screwdriver.
4. Lubricate the working edge of the oil seal with transmission grease and press it in using a mandrel of a suitable diameter with the working edge inside the gearbox.
5. Install the front wheel drive (see "Removal and installation front wheel drives").
6. Fill the gearbox with oil (see "Gearbox oil change").
7. The primary shaft seal is replaced on the gearbox removed from the vehicle after removing the clutch release drive slave cylinder with the clutch release bearing (see "Replacing the clutch release drive slave cylinder with the clutch release bearing"). Remove the seal with a screwdriver (or a specially made wire hook).
8. Lubricate the working edge of the oil seal with transmission grease and press it in using a mandrel of a suitable diameter with the working edge inside the box.
(For more information, please visit the website: FORDBOOK)