Replacing the height sensor (Scorpio 1)

1. Remove the ground wire from the battery.

2. Raise the rear of the vehicle and secure it on stands.

3. Remove the rocker arm joint and electrical connector from the sensor.

4. Unscrew the sensor from the bottom of the body and remove it.

5. Installation is carried out in the reverse order of removal.

The original article is available on the website www.FordBook.ru

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article reviewed: Herman Ostrovsky

« Previous articles
Removal and installation the compressor
Ground clearance adjustment system
Replacing wheel hub bearings
Removal and installation the stabilizer
Replacing the metal-rubber bushing of the rear axle beam

Next articles »

See other similar articles for Ford cars:
• Replacing the oil pressure warning light sensor Ford Focus 2 (2004-2010)
• Replacing the pressure sensor Ford Mondeo 4 (2007-2014)
• Replacing the coolant Ford Escort 3 (1980-1985)
• Replacing the coolant temperature sensor Ford Fiesta 2 (1983-1989)
• Checking and replacing the Hall sensor stator distributor block Ford Taurus 1 and 2 (1986-1994)
• Fuel filter water settling sensor (diesel only) Ford Transit 2 (1986-2000, diesel)