Replacing the oil pressure warning light sensor

The oil pressure warning light sensor is screwed into the cylinder block wall at the left front of the engine above the oil filter.

You will need a tall socket «at 24».

1. Install the car on a lift or inspection ditch and disconnect the wire from the terminal «minus» battery.

2. Wring out a clamp and disconnect a block of a plait of wires from the gauge.

3. Turn out the gauge from the block of cylinders and remove it.

NOTE: Replace the low oil pressure warning light sensor copper sealing washer with a new one each time the sensor is removed.

4. Install the oil pressure warning light sensor in the reverse order of removal.