Note: In this subsection, replacing the front wheel speed sensors is described using the left front wheel sensor as an example.
1. Disconnect the wire from the negative terminal of the battery.
2. Remove the front wheel (see "Wheel replacement").
3. Remove the front mudguard liner (see "Removal and installation wheel mudguards and fender liners").
4. Using a screwdriver, pry up the wheel speed sensor block…
5. … remove the shoe retainer from the hole in the body.
6. Disconnect the wheel speed sensor wiring harness connector.
7. Unscrew the mounting bolt…
8. …and remove the wheel speed sensor.
9. Install the sensor in the reverse order of removal.
10. Replace the right front wheel speed sensor in the same way.
To replace the rear wheel speed sensors do the following.
1. Disconnect the wire from the negative terminal of the battery.
2. Press the lock and disconnect the rear wheel speed sensor wiring harness connector.
3. Remove the sensor wiring harness connector from the holder.
4. Unscrew the mounting bolt…
5. …and remove the left wheel speed sensor.
6. Remove the right wheel speed sensor in the same way.
7. Press the lock and move the holder away.
8. Remove the wire harness from the holder.
9. Push the retainer into the beam…
10. …and remove the wheel speed sensor wiring harness mounting bracket from the rear suspension beam.
11. Install the rear wheel speed sensors in the reverse order of removal.
(This article is a copy from the website: «FORDBOOK.ru»)