Removal and installation of sensors of frequency of rotation of forward wheels

The front wheel speed sensor is mounted on the steering knuckle.

You will need a TORX T25 key.

1. Remove the wheel.

2. Disconnect a wire from the minus plug of the storage battery.

3. In the front wheel arch, clean the sensor harness pads from dirt..



4….and separate them.



5. Disconnect the sensor harness holders from the bracket on the body..



6.... and on the shock absorber strut.



7. Clear a block of a plait of wires and the sensor established on a rotary fist from dirt.



8. Squeezing the latches, disconnect the wiring harness block from the sensor.



9. Turn out the screw of fastening of the sensor..



10.... and remove the sensor from the steering knuckle hole.



11. Install the front wheel speed sensor in the reverse order of removal.