Contents: Initial conditions ↳ Regulating elements ↳
Headlight adjustment screws
 |
 |
A – all versions except Ghia, B – Ghia version
Fuse and relay box
1–20 – fuse designations (see table. List of fuses).
The headlight beam adjustment is performed using a headlight beam adjustment device.
Initial conditions
The tires of the wheels must be inflated to the required air pressure.
A vehicle with a full tank of fuel should only be loaded with a weight of 75 kg on the driver's seat.
The front of the vehicle should be pressed hard several times to properly position the elastic suspension elements.
Regulating elements
Changing the headlight beam setting is done by turning the screws located at the rear of the headlights (accessible from the engine compartment).
In the headlights, the lower screw is used for vertical adjustment (see Fig. Headlight adjustment screws) (A), and the upper screw is used for horizontal adjustment.
In the Ghia version (see fig. Headlight adjustment screws) (B), the lower screw (located behind the headlight) is used to adjust the installation of the additional headlights (high beam) in the vertical plane, and the upper screw (located above the headlight) is used to adjust the installation of the additional headlights (high beam) in the horizontal plane.
In the Ghia version, the front fog light adjustment is done using a screw located in the upper corner of the headlight, accessible from the outside at the front of the car.