Contents: Removal ↳ Installation ↳
Instrument cluster
A – basic version, L and GL, B – Ghia version, 1 – printed circuit board, 2 – case, 3 – casing, 4 – glass, 5 – speedometer, 6 – fuel level and coolant temperature gauge, 7 – tachometer
Removal
1. Disconnect the ground cable from the battery.
2. Remove the upper and lower steering column covers.
3. Carefully pry up and remove the instrument cluster illumination intensity control knob with a small screwdriver, as well as the intermittent wiper frequency control knob, and remove the multi-pin connector.
4. Unscrew the four screws securing the instrument cluster cover and remove the cover.
5. Unscrew the four instrument cluster mounting screws and move the instrument cluster forward slightly from the front panel. bolts after removing the plastic covers (the mounting screws are shown with arrows).
6. Disconnect the speedometer drive cable and (on the right side) the multi-pin connector for connecting the electrical wires.
Installation
To install the instrument cluster, perform the steps in reverse order to the removal process.
The original source of the publication is on the website [Fordbook.ru]