Fig. 148. Centering the driven disk from the inside of the clutch
- to center the driven disk, use the mandrel (number 16-067), which is shown in Fig. 148;
- apply a little plastic grease to the splines of the input shaft;
Fig. 149. Installing the clutch on the flywheel: 1 — clutch housing; 2 - pressure plate screws, 30 Nm; 3 - centering mandrel
- when installing the old clutch, install the clutch housing in accordance with the marking on the flywheel (Fig. 149). Tap around the circumference with a hammer so that it is installed well;
- tighten the clutch screws in several stages. Tightening torque 30 Nm. Check the alignment. When tightening the screws, prevent the flywheel from turning;
- install the drive;
- adjust the clutch pedal.