Removal and installation of an external mirror

Withdrawal

Disconnect the ground wire (-) from the battery.

Attention! As a result, data in electronic storage devices, such as an engine fault memory or a radio code, are erased. Please read the section carefully "Removing and installing the battery", before disconnecting it.

Remove the inner mirror cover. To do this, remove the plug with a small screwdriver, place a paper pad under the screwdriver to protect the lining from damage. Turn out a bolt of fastening.



Manual mirror adjustment: Remove the adjustment knob.

Electric mirror adjustment: Disconnect the multi-pin plug.



Turn out two bolts -1- and remove an external mirror.

Check seal -2- for damage and porosity.

Installation

Install and secure the mirror, making sure the gasket is properly compressed.

Put on the adjusting knob or connect the multi-pin plug.

Connect the ground wire to the battery terminal (-).

Set the time on the clock.

Set the radio's anti-theft code.