You will need: a 10 mm wrench and a flat-blade screwdriver.
1. Remove the front door trim (see "Removing and installing the front door trim").
2. Remove the front door glass (see "Replacing the front door glass").
NOTE: It is not necessary to remove the glass from the door; it is enough to disconnect it from the window lifter and fix it in the extreme upper position, for example, using a screwdriver, pieces of PVC pipe of a suitable diameter, or masking tape.
3. Pry it off with a screwdriver..
4. …push the lock drive cable seal cuff into the door…
5. …and three seal holders.
6. Squeeze the window regulator wiring harness connector clips…
7. …and disconnect the block from the gear motor.
8. Remove the rear window regulator from the holes in the base…
9. …and front wiring harness seals.
10. Remove the inner handle of the front door lock actuator (see "Replacing the inner handle of the front door lock actuator").
NOTE: It is necessary to remove the inner handle in order to disconnect the lock drive cable from it, which is passed through the hole in the base of the window regulator.
11. Remove the ten bolts securing the window regulator base to the door panel…
12. …and move the window regulator away from the door.
13. Disconnect the wiring harness connector from the door lock by squeezing its clips.
14. Remove the outside mirror wiring harness connector from the holder on the corner trim and remove the trim…
NOTE: The corner trim was removed during the glass removal process. If the glass was not removed, disconnect it from the door panel (see steps 3 and 4, "Replacing the Front Door Glass").
15. …squeeze the clamps…
16. …and disconnect the block.
17. Remove the wire harness holders from the holes in the door panel and the window regulator base and remove the window regulator, passing the harnesses through the technological holes in its base.