Checking engine parts (Sierra)

It is recommended to thoroughly clean and wash the parts that will be used again. Removing the plugs and caps from the cylinder block and cylinder head makes them much easier to clean. All gaskets and sealing rings should be replaced each time the engine is disassembled.

Checking the dimensions given in the technical specifications and comparing them with the actual values decides whether the part can be used further, repaired or replaced with a new one. The suitability of some parts is also indicated by the condition of their surface (scratches, cavities, etc.).

Information for this article was taken from the website FORDBOOK.RU

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article reviewed: Mikhail Dmitriev

« Previous articles
Disassembling a diesel engine
Removal and installation the engine
Cylinder head, valve timing adjustment
Cylinder head repair
Removal the cylinder head

Next articles »
Checking the crankshaft and connecting rod clearances
Assembly of a diesel engine
Diesel engine lubrication system
Diesel engine cooling system
Clutch — Description of changes