You will need a Phillips-head screwdriver.
1. Pre-check and, if necessary, adjust the air pressure in the tires to the correct level.
Fig. 4.6. Headlight adjustment
2. Place the car perpendicular to a smooth wall (e.g. in a garage) at a distance of 3 m. Place an additional weight of 75 kg on the driver's seat. Mark the screen on the wall as shown in Fig. 4.6. The longitudinal plane of symmetry of the car should pass along line 0 on the screen. Rock the car from the side so that the suspension springs self-align.
3. Measure the height of the headlight centers from the floor on your vehicle. This will be the distance h on the screen.
4. Set the headlight beam adjuster on the instrument panel to the position corresponding to the load of the vehicle with one driver.
5. Turn on the low beam.
6. Cover the right headlight with opaque material.
7. Open the hood and, by turning the adjusting screws of the left headlight, adjust the horizontal position of the light spot on the screen..
8. …and vertically, if the location of the light spots does not correspond to the drawing.
9. Adjust the right headlight in the same way.
Note: This is how the headlight adjustment screws are located.
10. The headlights are considered adjusted when the upper boundaries of the left parts of the light spots coincide with line 4, and vertical lines 1 and 2 pass through points E1 and E2 intersections of horizontal and inclined sections of light spots.
If the car is equipped with fog lights, the direction of their light beam must be adjusted only by height. Turn the adjusting screw until the upper edges of the light spots are on line 4 or slightly below it.