Contents: Removal ↳ Installation ↳
Special tool
 | HO2S Sensor Key 303-476 (T94P-9472-A) |
Removal
1. Remove the exhaust system heat shield.
2. Disconnect the heated oxygen sensor (HO2S) connector and release the clamp.
3. Using the special tool, remove the HO2S sensor.
Installation
CAUTION: When installing a new HO2S, it is possible that the replacement element will come with a longer cable than the one removed. It is important to route and secure the cable so that it cannot be damaged by heat or moving parts and cause noise, vibration, or harshness (NVH) problems.
1. Install the elements back in place in reverse order.
The original article can be viewed on the portal: FordBook