Crankshaft position sensor (CPS) (1.8 l diesel) (Focus 1)

Removal

1. Raise and support the vehicle. Refer to Section 100-02 for additional information.

2. Disconnect the crankshaft position sensor (CSP) electrical connector.

2. Disconnect the crankshaft position sensor (CSP) electrical connector.

3. Remove the CKP sensor.

Installation

1. Install the elements back in place in reverse order.

Content was created using data from this website www.FordBook.ru

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article reviewed: Yaroslav Gorbunov

« Previous articles
Crankshaft Position Sensor (CPS) (1.8L/2.0L/1.6L Zetec-E)
Crankshaft position sensor (CPS) (1.6L Zetec-SE/1.4L)
Camshaft Position Sensor (CMP) (1.8L/2.0L/1.6L Zetec-E)
Camshaft Position Sensor (CMP) (1.6L Zetec-SE/1.4L)
Diagnostics and checks

Next articles »
Crankshaft Position Sensor (CPS) (1.8L Diesel with Injection)
Power Steering Pressure (PSP) Switch (1.6L Zetec-SE/1.4L)
Power Steering Pressure (PSP) Switch (1.8L/2.0L/1.6L Zetec-E)
Powertrain Control Module (PCM)
Idle Air Control Valve (1.6L Zetec-SE/1.4L)

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet

Focus 2

Focus Turnier 1
Focus 1