Crankshaft Position Sensor (CPS) (1.8L/2.0L/1.6L Zetec-E) (Focus 1)

Removal

1. Raise and support the vehicle. Refer to Section 100-02 for additional information.

2. Disconnect the crankshaft position sensor (CSP) electrical connector.

2. Disconnect the crankshaft position sensor (CSP) electrical connector.

3. Remove the CKP sensor.

Installation

1. Install the elements back in place in reverse order.

This article was borrowed from the website [FORDBOOK.ru]

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article reviewed: Yaroslav Gorbunov

« Previous articles
Crankshaft position sensor (CPS) (1.6L Zetec-SE/1.4L)
Camshaft Position Sensor (CMP) (1.8L/2.0L/1.6L Zetec-E)
Camshaft Position Sensor (CMP) (1.6L Zetec-SE/1.4L)
Diagnostics and checks
Description and operating principle of electronic controls

Next articles »
Crankshaft position sensor (CPS) (1.8 l diesel)
Crankshaft Position Sensor (CPS) (1.8L Diesel with Injection)
Power Steering Pressure (PSP) Switch (1.6L Zetec-SE/1.4L)
Power Steering Pressure (PSP) Switch (1.8L/2.0L/1.6L Zetec-E)
Powertrain Control Module (PCM)

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet

Focus 2

Focus Turnier 1
Focus 1